Filter
Top Products
KZPCM PCI–to–Dual Channel Ultra SCSI and 10/100MB Ethernet Host Adapter
3–2 EK–KZPCM–UG. B01
Figure 3–1
Configuration Utility
Main Menu
MAIN MENU
Port IRQ – Status – NVRAM
Num Level Current Next-Boot Found
1 SYM53C875 8400 10 ON ON YES
2 SYM53C875 8600 10 ON ON YES
B….…Adapter Boot Order
C….…Change Adapter Status
D….…Display Mode = Verbose
M….…Mono/Color
F1…..Help
Q….…Quit
Use arrow keys to select from menu. Then press ENTER
3.2 Descriptions of the Main Menu Selections
The selections in the Main Menu have the following meanings:
•
Select Current SCSI Channel [
1(2
)]
– Highlight one of the SCSI channels
using the arrow keys to select the adapter or channel you wish to modify.
One entry will be available for each adapter in the system. The following
selections are global and refer to all adapters found in the system.
• Adapter Boot Order
[B]
– Allows you to select the order in which the host
system will scan the adapters, allowing a re-ordering of boot devices.
Choice will only appear in the menu if more than one adapter channel is
found.
• Change Adapter Status
[C]
– Allows adapters or channels to be disabled, so
they will not be made available to the operating system on subsequent
system boots until being re-enabled. This feature should be used only during
system debug.
• Display Mode
[D]
– Changes default message format from Verbose to Terse.
• Mono/Color
[M]
– Changes screen from color to monochrome.
• Help
[F1]
– On screen help utility. Provides help on current menu screen.
•
Quit
[Q]
– Exit the utility.