KZPCM PCI–to–Dual Channel Ultra SCSI and 10/100MB Ethernet Host Adapter
4–2 EK–KZPCM–UG. B01
•
Multiple Logical Unit Numbers (LUNs)
•
Disconnect/Reselect
•
Scatter-gather
•
SCSI pass-through functionality
•
Bus device reset Scan order change (scans the bus from SCSI ID 0 to MAX
SCSI ID [7 or 15].
•
Disk array configurations with no LUN 0.
•
Disk array configurations with noncontiguous LUNs
•
Ultra SCSI (20Mb/sec narrow, 40 Mb/sec wide)
4.2 Installing the SYMC8XX.SYS Miniport Driver
You can install the driver in a new system or in an existing system using the
method described here.
NOTE
Refer to the file READ_ME.TXT on the installation
disk for additional information about this
procedure.
This procedure installs the SYMC8XX.SYS driver in a Windows NT Alpha
system. Use this procedure when installing NT on an Alpha system with an
unused SCSI driver or on one where a driver already exists. NT adds the driver to
the registry and copies the driver to the appropriate directories. The KZPCM
Host Adapter using the Symbios Logic 875 Ultra SCSI controller supports
installation of the system disk provided the base system has support in the
AlphaBIOS console for the 875 controller chip.
Because the drivers on the NT CD do not support the KZPCM Host Adapter by
default, manual intervention of the installation process is required. Follow these
steps to install the driver.
1. Boot Windows NT and log on as Administrator.
2. When the
Start/Settings/Control Panel
selections appear, select
SCSI
Adapters
; then select
Drivers
.
3.
If
NCRSDMS.SYS, NCRC810.SYS, NCRC8XX.SYS, NCR PCI (53C810)
drivers or
Symbios Logic C810
drivers are listed, select them and choose
REMOVE
before adding the new driver. Select
Yes
when the Setup message
prompts,
“Are you sure you want to remove the selected driver?”