Juniper Networks M10i Network Router User Manual


 
ATM2 E3 IQ PIC
JUNOS 6.1 and laterSoftware release
Two E3 ports
Power requirement: 0.41 A @ 48 V (20 W)
Intelligent queuing (IQ) PICs support fine-grained queuing per logical interface
ATM standards compliant
Description
16-MB SDRAM memory for ATM segmentation and reassembly (SAR)
ATM switch ID
Configurable framing options:
G.751 direct mapping
G.751 with PLCP encapsulation (default)
G.832 ATM direct mapping
Internal and loop timing
Hardware features
Per-virtual circuit (VC) and per-virtual path (VP) traffic shaping
Unspecified bit rate (UBR) traffic shaping
Fine-grained variable bit rate (VBR) traffic shaping
Circuit cross-connect (CCC)
ATM Inverse Address Resolution Protocol (ARP), which enables routers to automatically
learn the IP address of the router on the far end of an ATM permanent virtual circuit
(PVC)
Simple Network Management Protocol (SNMP):
Management Information Base (MIB) 2 (RFC 1213)
ATM MIB (RFC 1695)
SONET MIB
AAL5 encapsulations:
ATM-VC-MUX
ATM-NLPID
ATM-Cisco-LLPID
ATM-SNAP
ATM-CCC-VC-MUX
Software features
10 ft (3.05 m) posilock SMB to BNC (provided)
Four pairs of Rx and Tx coaxial cables
Cables and connectors
ATM2 E3 IQ PIC 11
ATM2 E3 IQ PIC