Juniper Networks M10i Network Router User Manual


 
Channelized E1 IQ PIC
JUNOS 6.1 and laterSoftware release
Ten E1 ports
Power requirement: 0.15 A @ 48 V (7.2 W)
Intelligent queuing (IQ) PICs support fine-grained queuing per logical interface.
Channelization: E1, DS0
Description
Data service unit (DSU) functionality
Ports configurable as clear channel E1 interfaces with 2.048-Mbps connectivity
Supports unframed E1 G.703 and G.704 framing modes
Supports HDB3 line coding
CRC4 configurable
Local and remote loopback testing
Hardware features
Quality of service (QoS) per channel: weighted round-robin (WRR), random early detection
(RED), weighted random early detection (WRED)
Simple Network Management Protocol (SNMP): E1 MIB, DS0 MIB
Dynamic, arbitrary channel configuration
Full bit error rate test (BERT)
Encapsulations:
High-Level Data Link Control (HDLC)
Frame Relay
Circuit cross-connect (CCC)
Translational cross-connect (TCC)
Point-to-Point Protocol (PPP)
Software features
120-ohm RJ-48CCables and connectors
One bicolor per E1 port:
OffPort not enabled
GreenPhysical E1 link is up; individual subchannels can be down
RedPhysical E1 link is down
LEDs
20 Channelized E1 IQ PIC
M10i Internet Router PIC Guide