Juniper Networks M10i Network Router User Manual


 
Gigabit Ethernet IQ PIC with SFP
JUNOS 6.1 and laterSoftware release
One Gigabit Ethernet port
Power requirement: 0.46 A @ 48 V (22 W)
Intelligent queuing (IQ) PICs support fine-grained queuing per-logical interface.
Description
High-performance throughput at speeds up to 1 Gbps
Full-duplex mode
Large MTUs of up to 9192 bytes
Hardware features
Optical diagnostics and related alarms (JUNOS Release 8.2 and later)
Quality of service (QoS) per channel: Weighted round-robin (WRR), Random early drop
(RED), Weighted random early drop (WRED)
Virtual Router Redundancy Protocol (VRRP) support
802.1Q Virtual LANs
VLAN stacking and rewriting
MAC policing, accounting, and filters
Flexible Ethernet encapsulation
JUNOS Release 7.0 or later is required to configure graceful Routing Engine switchover
(GRES).
Software features
The Gigabit Ethernet IQ PICs use small form factor-pluggables (SFPs) that allow different
interfaces to be used on the PIC. For information about installing and removing SFPs,
see the M10i Internet Router Hardware Guide.
SX, LX, and LH SFPs:
Duplex LC/PC connector (RX and TX)
Optical interface supportSee Table 10 on page 50
1000Base-T SFPs:
Connector: Four-pair, Category 5 shielded twisted pair connectivity through an RJ-45
connector
Pinout: MDI crossover
Length: 328 ft/100 m
Cables and connectors
Gigabit Ethernet IQ PIC with SFP 49
Gigabit Ethernet IQ PIC with SFP