Juniper Networks M10i Network Router User Manual


 
Gigabit Ethernet PIC with SFP
JUNOS 6.3 and laterSoftware release
One Gigabit Ethernet port
Power requirement: 0.15 A @ 48 V (7.3 W)
Supports large Ethernet frame sizes for more efficient throughput across the intra-POP
network
Description
High-performance throughput on each port at speeds up to 1 Gbps
Autonegotiation between Gigabit Ethernet circuit partners
Full-duplex mode
Maximum transmission units (MTUs) of up to 9192 bytes
Hardware features
Virtual Router Redundancy Protocol (VRRP) support
802.1q virtual LANs (VLANs) support
960 destination MAC filters per port
Flexible Ethernet encapsulation
Multiple tag protocol identifiers (TPID) support
Source MAC learning
MAC accounting and policingDynamic local address learning of source MAC addresses
Software features
You can install any transceiver supported by the PIC. For information about installing
and removing transceivers, see the PIC and Transceiver Installation Instructions.
Fiber-optic SFP transceivers:
Duplex LC/PC connector (Rx and Tx)
Optical interface supportSee Table 9 on page 48
1000Base-T SFP transceivers:
Connector: Four-pair, Category 5 shielded twisted-pair connectivity through an RJ-45
connector
Pinout: MDI crossover
Length: 328 ft/100 m
NOTE: Do not install Gigabit Ethernet SFPs in the SONET/SDH port. The port will not recognize
the SFP.
Cables and connectors
Gigabit Ethernet PIC with SFP 47
Gigabit Ethernet PIC with SFP