Juniper Networks M10i Network Router User Manual


 
Channelized STM1 IQ PIC
JUNOS 6.1 and laterSoftware release
One STM1 port
Power requirement: 0.39 A @ 48 V (18.6 W)
Intelligent queuing (IQ) PICs support fine-grained queuing per logical interface
Channelization: STM1c, fractional E1, framed and unframed DS0
Description
Packet buffering, Layer 2 parsing
Local and remote loopback testing
Hardware features
Quality of service (QoS) per channel: weighted round-robin (WRR), random early detection
(RED), weighted random early detection (WRED)
SNMP: SONET/SDH MIB, T1/E1 MIB
Dynamic, arbitrary channel configuration
Full bit error rate test (BERT) patterns at E1 and DS0 levels
Encapsulations:
High-Level Data Link Control (HDLC)
Frame Relay
Circuit cross-connect (CCC)
Translational cross-connect (TCC)
Point-to-Point Protocol (PPP)
Software features
Duplex SC/PC connector (Rx and Tx); single-mode intermediate-reach fiberCables and connectors
One tricolor per port:
OffNot enabled
GreenOnline with no alarms or failures
AmberOnline with alarms for remote failures
RedActive with a local alarm; router has detected a failure
LEDs
28 Channelized STM1 IQ PIC
M10i Internet Router PIC Guide