Juniper Networks M10i Network Router User Manual


 
E3 PIC
JUNOS 6.0 and laterSoftware release
Two E3 ports
Power requirement: 0.47 A @ 48 V (22.5 W)
Integrated DSU interoperability
Description
High-density E3 (34.368-Mbps) connectivity
High-performance throughput on each port at speeds up to 34.368 Mbps, full duplex
Scrambling support
Subrate clocking support
Rate policing on input
Rate shaping on output
Packet buffering, Layer 2 parsing
Large MTUs, up to 9192 bytes
Local and remote loopback
Hardware features
Supports G-751 framing
E3 diagnostics and loopback control
E3 alarm and event counting and detection
DS3 diagnostics and loopback control
Bit error rate test (BERT); you can configure one port in BERT mode and configure the
remaining channels to transmit and receive normal traffic
Encapsulations:
High-level Data Link Control (HDLC)
Frame Relay
Multiprotocol Label Switching (MPLS) circuit cross-connect (CCC)
Point-to-Point Protocol (PPP)
Software features
Custom 10 ft (3.05 m) posilock to BNC male cable, separate RX and TXCables and connectors
One tricolor per port:
OffNot enabled
GreenOnline with no alarms or failures
AmberOnline with alarms for remote failures
RedActive with a local alarm; router has detected a failure
LEDs
36 E3 PIC
M10i Internet Router PIC Guide