Filter
Top Products
SONET/SDH OC3c/STM1 PIC
■
JUNOS 6.1 and later (Type 1)
NOTE: Although the illustration shows a multimode PIC, both a multimode PIC and a
single-mode intermediate reach PIC are supported.
Software release
■
Four OC3 ports
■
Power requirement: 0.49 A @ 48 V (23.7 W)
Description
■
Multiplexing and demultiplexing
■
Rate policing on input
■
Rate shaping on output
■
Packet buffering, Layer 2 parsing
Hardware features
■
SONET/SDH framing
■
Link aggregation
■
Alarm and event counting and detection
■
Dual-router automatic protection switching (APS)
■
Multiprotocol Label Switching (MPLS) fast reroute
■
Encapsulations:
■
High-Level Data Link Control (HDLC)
■
Frame Relay
■
Circuit cross-connect (CCC)
■
Translational cross-connect (TCC)
■
Point-to-Point Protocol (PPP)
Software features
■
Duplex SC/PC connector (Rx and Tx)
■
Optical interface support—See Table 13 on page 58
NOTE: To extend the life of the laser, when a PIC is not being actively used with any valid
links, take the PIC offline until you are ready to establish a link to another device. For
information about taking a PIC offline, see the request chassis pic offline command in the
JUNOS System Basics and Services Command Reference.
Cables and connectors
One tricolor per port:
■
Off—Not enabled
■
Green—Online with no alarms or failures
■
Amber—Online with alarms for remote failures
■
Red—Active with a local alarm; router has detected a failure
LEDs
SONET/SDH OC3c/STM1 PIC ■ 57
SONET/SDH OC3c/STM1 PIC