Filter
Top Products
When an Error Message is Displayed
v
Check the error code and error code number displayed on the
operation panel.
.
List of Error Codes
v
Click on an error code below to jump to the page with the
corresponding error descriptions.
"44" (A page 45) "90" (A page 44) "91" (A page 44)
"92" (A page 44) "93" (A page 44) "94" (A page 44)
"95" (A page 44)
"A1" (A page 44) "A2" (A page 44) "A8" (A page 44)
"AB" (A page 45) "AC" (A page 45)
"B0" (A page 44) "B1" (A page 44) "B2" (A page 45)
"C1" (A page 45) "C2" (A page 45) "C3" (A page 45)
"D1" (A page 44) "D8" (A page 45)
"F0" (A page 45) "F1" (A page 45) "F2" (A page 45)
"F3" (A page 45) "F4" (A page 45) "F5" (A page 45)
"F6" (A page 45) "F8" (A page 45)
No Card
.
v
Cards have run out.
"Replenish the cards." (A page 31)
v
The card hopper is not installed.
Install the card hopper.
Memo:
v
The operation panel display appears blinking when the cards have
run out or when the card hopper is not installed.
Jam(Hopper) 90
.
v
Card jam near the card hopper and cleaning roller.
"Remove the jammed card." (A page 46)
Jam(TurnOver) 91
.
v
Card jam near the card turn over unit.
"Remove the jammed card." (A page 47)
Jam(MG) 92
.
v
Card jam in the magnetic encoder unit.
"Remove the jammed card." (A page 49)
Jam(Transfer) 93
.
v
Card jam in the card feed roller.
"Remove the jammed card." (A page 50)
Jam(Discharge) 94
.
v
Card jam near the card outlet.
"Remove the jammed card." (A page 51)
Jam(Retran.) 95
.
v
Card jam near the retransfer heating roller.
"Remove the jammed card." (A page 52)
Film Search A1
.
v
Retransfer film is broken.
"Repair the retransfer film." (A page 56)
MG Test Err A8
.
v
A writing error has occurred during magnetic encoder self-diagnosis.
Press KNB to reset the printer.
Ink Error B0
.
v
An incorrect ink ribbon is installed.
Install a correct ink ribbon.
Ink Search B1
.
v
Ink ribbon is broken.
"Repair the ink ribbon." (A page 54)
Door Open D1
.
v
The printer door is open.
Close the printer door, and press KNB to reset the printer.
v
Cleaning unit is not installed.
Install the cleaning unit, close the printer door, and press
KNB to reset the printer.
Memo:
v
The operation panel display appears blinking when the printer door
is open or when the cleaning unit is not installed.
Film Run Out A2
.
v
Retransfer film has run out.
"Replace with a new one." (A page 33)
Troubleshooting
44