Filter
Top Products
Retransfer Film
Retransfer Film has Run Out
v
"Replace with a new retransfer film." (A page 33)
Retransfer Film is Broken
v
Repair the retransfer film.
Cautions:
v
If the security lock is on, deactivate it. After work is complete,
activate the security lock again.
v
Stand the cassette on a flat surface as illustrated in the diagram.
Avoid doing so on the floor as dust attached to it may cause printing
errors.
.
v
Do not touch the retransfer face (the side that faces outward when
installed) with your hand. Touching it may cause printing errors. Put
on the supplied gloves when handling the retransfer film.
v
The cassette is heavy when the retransfer film is loaded. To prevent
the cassette from dropping during handling, make sure to hold it with
both hands.
v
When installing a used retransfer film, align the unused side of the
film with the arrow indicated on the label of the cassette. Improper
alignment may result in errors, or the print may turn out light.
v
Do not perform any work on the printer door. Do not place heavy
objects or apply load on the printer. Doing so may damage it.
v
During replacement, clean the four bobbin holders on the printer. If
burrs produced by friction with the bobbins are attached to the
bobbin holders, they may fall onto the card, ink ribbon, or retransfer
film, causing printing errors.
"Cleaning the bobbin holders" (A page 40)
1
Open the printer door
.
2
Press and hold down the cassette button, and remove the retransfer
film cassette (on the left)
.
3
Cut away the broken portion, and attach the unused portion at the
supply side to the other end at the take-up side using an adhesive
tape, while making sure that the joint surface is even
Cautions:
v
Do not discard the used retransfer film at the take-up side.
4
Turn the take-up side using your hand until the broken portion can
no longer be seen
.
v
Align the film side of the unused portion with the arrow indicated on
the label of the cassette.
5
Remove any slack in the film
.
6
Insert the cassette all the way in along the guide rail until a “click”
sound is heard, followed by closing the printer door
.
.
7
Press KNB to reset the printer
.
Memo:
v
To avoid printing errors, it is recommended that you forward by one or two
images after installing the ink ribbon cassette or retransfer film cassette.
"Initializing printer when installing the cassette" (A page 22)
Troubleshooting
56