Kyocera 2050 All in One Printer User Manual


 
Appendix
Appendix-5
Special Paper
This section describes printing onto special paper other than standard paper.
You can use the following types of special paper in this machine.
Transparency
Preprinted paper
Label
Bond paper
Recycled paper
Thin paper (45 to 64 g/m²)
Letterhead
Color paper
Prepunched paper
Envelope
Postcard
Thick paper (90 to 160 g/m²)
High-quality paper
For these types of paper, use paper specified for copiers or page printers. When using
transparencies, labels, thin paper, envelopes, postcards, or thick paper, feed the paper from the
multi-bypass tray.
Selection of Special Paper
Special paper that satisfies the conditions shown on and after the next page can be used in this
machine. However, since special paper differs significantly in paper composition and quality, special
paper is more likely to cause problems than standard paper during printing. When using special
paper, perform trial printing using this machine and check to see if the results are satisfactory before
purchasing it. Notes in printing for principal types of special paper are described on and after the
next page. Kyocera Mita shall not be liable for any danger to a person or machine that is caused by
using special paper (e.g., special paper affected by moisture).
Transparency
Transparencies must withstand the heat of fusing during the printing process. The recommended
transparency product is shown below.
3M CG3700 (Letter, A4)
The specifications of transparencies that can be used in this machine are shown in the table below.
To avoid problems, feed transparencies from the multi-bypass tray. Be sure to set them with the long
side toward the main body.
If transparencies cause paper jams frequently, pull the end of the transparencies carefully each time
one sheet is output.
Item Specifications
Heat resistance Must withstand heat at least 190 °C.
Thickness 0.100 to 0.110 mm
Material Polyester
Size tolerance ±0.7 mm
Squareness of corners 90° ±0.2°