Filter
Top Products
59
Section 3: IBM Emulation Mode Printer Commands
Set Top of Form and Page Length
Set Top of Form
This command sets the first line of printing on each page to the current paper
position.
Set Page Length in Inches
This command sets the page length to a specified number of inches.
Usage Notes
• The value of n is the number of inches you want to set as the page length
and must be between 1 and 255.
• When the command is sent, the current vertical position becomes the new
top of form.
• If the printer command Set Skip Perforation (ESC N) is active, or if "skip
over perforation" is On in the printer setup, this printer command deacti-
vates it.
Set Page Length in Lines
This command sets the page length to a specified number of lines.
Usage Notes
• The value of n is the number of lines you want to set as the page length and
works in conjunction with the current line spacing (ESC A).
Format ESC 4
Decimal 27 52
Hex 1B 34
Format ESC C 0 inches
Decimal 27 67 0 n
Hex 1B 43 00 n
Format ESC C lines
Decimal 27 67 n
Hex 1B 43 n