Section 3: IBM Emulation Mode Printer Commands
60
• When the command is sent, the current vertical position becomes the new
top of form.
• If the printer command Set Skip Perforation (ESC N) is active, or if "skip
over perforation" is On in the printer setup, this printer command deacti-
vates it.
Set Skip Perforation
This command specifies the number of lines to be skipped at the bottom of each
page, which creates a bottom margin.
Usage Notes
• This command remains in effect until:
— Cancel Skip Perforation (ESC O) printer command is received.
— Set Page Length in Lines (ESC C) printer command is received.
— Set Page Length in Inches (ESC C 0) printer command is received.
• Valid values for n are 1 through 255 (decimal), 01 through FF
(hexadecimal).
• To cancel this printer command, use Cancel Skip Perforation (ESC O).
Cancel Skip Perforation
This command cancels Set Skip Perforation (ESC N).
Format ESC N lines
Decimal 27 78 n
Hex 1B 4E n
Format ESC O
Decimal 27 79
Hex 1B 4F