Filter
Top Products
Section 5: OKI Microline Emulation Mode Printer Commands
88
Vertical Movement
Name Dec Hex Description
ESC G 27 71 H
n
L
n
1B 47 H
n
L
n
Set Page Length in Inches
Sets the page length in increments of 1/2" x the
values of H
n
L
n
.
The values for H
n
and L
n
should be between 00
and 99. For lengths less than 4.5", H
n
= 0.
ESC F 27 70 H
n
L
n
1B 46 H
n
L
n
Set Page Length in Lines
Sets the page length in increments of
line pitch x the values of H
n
L
n
.
The values for H
n
and L
n
should be between 00
and 99. For values less than 10, H
n
= 0.
ESC % S 1 27 37 83 49 1B 25 53 31 Select Skip Over Perforation
Skips an inch from the bottom of one page to the
top of the next.
ESC % S 0 27 37 83 48 1B 25 53 30 Cancel Skip Over Perforation
FF 12 0C Form Feed (with carriage return)
Advances the paper to the top of the next page.
LF 10 0A Line Feed (with carriage return)
Advances the form one line.
ESC DC2 27 18 1B 12 Graphics Line Feed (without carriage return)
Advances the form one line without returning to
the left margin. Allows you to overstrike a line of
printing and to create special effects like double
underlines.
ESC ? n : 27 63 n 58 1B 3F n 3A Carriage Return/Feed Selection
Value of n Operation
33 Carriage return only
34 Forward line feed, no carriage return
35 Forward line feed w/carriage return
48 Reverse line feed, no carriage return
49 Reverse line feed w/carriage return
ESC % 5 n 27 37 53 n 1B 25 35 n
Perform n/144" Line Feed
0 < n < 127
ESC VT 27 11 H
n
L
n
1B 0B H
n
L
n
Skip Down Select Number of Lines
ESC LF 27 10 1B 0A Reverse Line Feed
ESC 6 27 54 1B 36 Set Line Spacing to 1/6"
ESC 8 27 56 1B 38 Set Line Spacing to 1/8"
ESC % 9 27 37 57 n 1B 25 39 n
Set Line Spacing to n/144"