Filter
Top Products
89
Section 5: OKI Microline Emulation Mode Printer Commands
Other Commands
DC4
SP...SP n...
SP...SP n...?
20 32...32
n... 32...32
n... 63
14 20...20 n...
20...20 n... 3F
Set Vertical Format Unit (VFU)
Programs up to 12 sets (channels) of vertical tabs.
The maximum tab stops in one set (channel) is 27.
This command works in conjunction with the VT
command followed by a channel code (n). When
the VT command is received, the printer skips to
the next tab stop in that channel.
To set your tabs, follow the DC4 code with one SP
code for each line to be skipped in order to
advance to the line where you want your first tab
stop. For example, the command
DC4 32 32 32 5 32 12 32 32 20 32 32 32 32....32 63
causes the printer to skip 3 lines, enters a tab stop
at 5, skips 1 line, enters a tab stop at 12, skips 2
lines, enters a tab stop at 20, and then skips
however many lines remain on the page.
VT 11 n 0B n
Vertical Tab
Advances the paper to the next vertical tab stop.
Valid channel codes are 49 through 60.
ESC 5 27 53 1B 35 Set Top of Form
Name Dec Hex Description
CAN 24 18 Cancel Data
Clears all data from the print buffer, but does not
reset printing features.
ESC { 27 123 n 1B 7B n
Change Emulation
When n=2 the emulation changes to IBM
Proprinter.
When n=65 the emulation changes to Epson.
ESC CAN 27 24 1B 18 Initialize Printer
Clears all data from the print buffer, and returns
the printer to the current menu settings.
ESC < 27 60 1B 3C Select Half-speed Printing
ESC > 27 62 1B 3E Cancels Half-speed Printing
ESC E 0 27 69 0 1B 45 00 Select Paper-out Sensor
ESC E 1 27 69 1 1B 45 01 Cancel Paper-out Sensor
DC3 19 13 Select Print Suppress Mode
DC1 17 11 Cancel Print Suppress Mode
ESC { NUL 27 125 0 1B 7D 00 Software-Prime
Name Dec Hex Description