Filter
Top Products
3-15 4059 Service Manual
4059-XXX
The multipurpose tray and the envelope feeder do not have a paper
low sensor. The multipurpose tray does not have a pass thru sensor.
OutputBinTest-StandardBin
This test is used to verify if the standard bin sensor is working
correctly.
To run the Standard Bin Sensor Test:
1. Select Output Bin Tests from the Diagnostic Menu.
2. Select Output Bin Tests - Sensor Tests.
3. Select Sensor Tests - Standard Bin.
– “Standard Bin/Full=CL” message displays.
Manually actuate the bin sensor by moving the flag in and out of the
sensor. The display indicates OP (open) when the flag is out of the
sensor and CL (closed) when the flag is in the sensor.
4. Press Return/Stop to exit the test.
OutputBinFeedTest
Note: If the “Configure Bins” printer setting is link rather than
mailbox, the printer selects its own internal bin linking regardless of
which output bin is selected for the feed test
This test is to verify that media can be fed to a specific output bin. No
information is printed on the media because the printhead is not
turned on during this test.
To run the Output Bin Feed Test:
1. Select Feed Test from the Output Bin Test menu.
2. Select the output bin you want the paper to exit into. All output
bins installed on the printer are shown on the feed test menu.
3. Select either Single (one sheet of media feeds to the selected
output bin) or Continuous (media continues feeding to the
selected output bin) until Return/Stop is pressed.
4. Press Return/Stop to exit the test.