Filter
Top Products
Diagnostic Information 2-18
4059-XXX
36 Resolution Reduced The resolution of the page has been reduced
from 600 dpi to 300 dpi in order to prevent a
Memory Full error. This message can only occurif
the Resolution Reduction setting is turned on.
Note: 1200 dpi pages are not resolution reduced.
If a 1200 dpi job runs out of memory, a Memory
Full error is displayed.
37 Insufficient Collation
Memory
This message is displayed when the printer
memory used to store pages is too full to collate
the print job.
38 Memory Full This message is displayed when the printer
memory used to store pages is full.
39 Complex Page This message is displayed when the page is too
complex to print.
51 Defective Flash This message is displayed when the printer
detects a defective flash. This error may occur at
power on, or during flash format and write
operations. Press Go to clear the message. The
flash is marked as bad and normal operation
continues. Flash operations are not allowed until
the problem is resolved.
52 Flash Full This message is displayed when there is not
enough free space in the flash memory to hold
the resources that have been requested to be
written to flash.
53 Unformatted Flash This message is displayed when the printer
detects an unformatted flash at power on. Press
Go to clear the message. The flash is marked as
bad and normal operation continues. Flash
operations are not allowed until the flash is
formatted.
54 Standard Serial Error This error is displayed when a serial error
(framing or parity) is detected on the standard
serial port. This usually indicates the serial port is
not set up correctly.
54 Serial Option X Error This error is displayed when a serial error
(framing or parity) is detected on the optional
serial port. This usually indicates the optional
serial port is not set up correctly.
User Error Message Explanation