Filter
Top Products
3-23 4059 Service Manual
4059-XXX
The contents of the Print Test Page varies depending on the media
installed in the selected input source.
Note: The Print Test Page always prints on one side of the paper,
regardless of the duplex setting or the presence of a duplex option.
To run the Print Test Page:
1. Select Print Tests from the Diagnostic menu.
2. Select the media source.
3. Select Single or Continuous.
– If single is selected no buttons are active during printing.
– If continuous is selected, Return or Stop can be selected to
cancel the test.
Check each Test Page from each source to assist in Print Quality
and Paper Feed problems.
Print Quality Test Pages
The purpose of this diagnostic function is to allow printing of the print
quality test pages with the toner cartridge lockout function disabled.
The print quality test consists of three pages. Page one contains a
mixture of graphics and text. Pages two and three only contain
graphics. If duplex is turned On, the pages are duplexed, otherwise
the pages are printed on one side. The Print Quality Test pages
must always be printed on letter, legal or A4 paper.
To run the Print Quality Test Pages:
1. Turn the printer off.
2. Press and hold Select and Return.
3. Turn on the printer.
4. Release the buttons once Performing the Self Test displays.
5. The printer performs its normal POR cycle then print one copy
of the Print Quality Test pages. If you want more than one copy,
perform these steps again.