National Instruments GPIB-COM Switch User Manual


 
Contents
© National Instruments Corporation ix GPIB-COM User Manual
Figures
Figure 1-1. GPIB-COM Board ................................................................................................ 1-2
Figure 2-1. GPIB-COM Parts Locator Diagram...................................................................... 2-1
Figure 2-2. Possible Settings for GPIB-COM Jumpers........................................................... 2-4
Figure 2-3. Jumper W1 Settings .............................................................................................. 2-4
Figure 2-4. Switch Setting for REN* OFF, IFC* ON, SRQ* ON, and Listen Address 5 ...... 2-5
Figure 2-5. Listen Address Setting for Listen Address 10 Hex................................................ 2-6
Figure 2-6. Switch Setting for REN* ON, IFC* OFF, and SRQ* OFF.................................. 2-7
Figure 3-1. Block Diagram of GPIB-COM ............................................................................. 3-2
Figure 4-1. Plotter Output......................................................................................................... 4-2
Figure C-1. GPIB Cable Connector .......................................................................................... C-3
Figure C-2. Linear Configuration of the GPIB Devices............................................................ C-5
Figure C-3. Star Configuration of GPIB Devices ..................................................................... C-6
Tables
Table 2-1. IBM PC Serial Port Adapters ................................................................................ 2-3
Table 2-2. Factory Default Settings and Optional Configurations........................................... 2-3
Table 5-1. GPIB-COM Registers ........................................................................................... 5-1
Table 5-2. Interrupt Types and Priorities................................................................................. 5-7
Table 5-3. Word Length Select Bits........................................................................................ 5-9