Filter
Top Products
Index
National Instruments Corporation I -3 VXI-MIO Series User Manual
D
DAC0OUT signal
analog output connections, 4-20 to 4-21
description (table), 4-3
VXI-MIO-64E-1 (table), 4-6
VXI-MIO-64XE-10 (table), 4-8
DAC1OUT signal
analog output connections, 4-20 to 4-21
description (table), 4-3
VXI-MIO-64E-1 (table), 4-6
VXI-MIO-64XE-10 (table), 4-8
DAQ-STC, C-1
data acquisition timing connections,
4-25 to 4-34
AIGATE signal, 4-33 to 4-34
CONVERT* signal, 4-32 to 4-33
EXTSTROBE* signal, 4-26 to 4-27
posttriggered acquisition (figure), 4-25
pretriggered acquisition (figure), 4-26
SCANCLK signal, 4-26
SISOURCE signal, 4-34
STARTSCAN signal, 4-30 to 4-31
TRIG1 signal, 4-27 to 4-28
TRIG2 signal, 4-28 to 4-29
DGND signal
description (table), 4-3
digital I/O connections, 4-22
power connections, 4-23
VXI-MIO-64E-1 (table), 4-6
VXI-MIO-64XE-10 (table), 4-8
DIFF (differential) input mode
definition (table), 3-3
description, 4-14
ground-referenced signal sources, 4-15
illustration, 4-15
nonreferenced or floating signal sources,
4-16 to 4-17
illustration, 4-16
recommended configuration
(figure), 4-13
single-ended connections, 4-18
floating signal sources (RSE), 4-19
grounded signal sources (NRSE),
4-19 to 4-20
when to use, 4-14
digital I/O
common questions about, C-4 to C-6
operation, 3-14
signal connections, 4-22 to 4-23
specifications
VXI-MIO-64E-1, A-7
VXI-MIO-64XE-10, A-14
digital trigger specifications
VXI-MIO-64E-1, A-8
VXI-MIO-64XE-10, A-16
DIO<0..7> signal
description (table), 4-3
digital I/O connections, 4-22 to 4-23
VXI-MIO-64E-1 (table), 4-6
VXI-MIO-64XE-10 (table), 4-8
dither
enabling, 3-7 to 3-8
signal acquisition effects (figure), 3-8
documentation
conventions used in manual,
xii
National Instruments documentation,
xiii
organization of manual,
xi-xii
related documentation,
xiv
DRAM configuration (table), 2-6 to 2-7
dynamic characteristics
analog input
VXI-MIO-64E-1, A-4
VXI-MIO-64XE-10, A-12
analog output
VXI-MIO-64E-1, A-6
VXI-MIO-64XE-10, A-13
E
EEPROM
loading USER/FACTORY configuration,
2-7 to 2-8
protecting/changing factory
configuration, 2-8
storage of calibration constants, 5-1