Filter
Top Products
Chapter 2 Configuration and Installation
VXI-MIO Series User Manual 2-8
National Instruments Corporation
Figure 2-5.
Load User/Factory Configuration
Protect/Change Factory Configuration
Use switch S1 to change the factory-default configuration settings by
permitting writes to the factory settings section of the EEPROM. This
switch serves as a safety measure and should not be needed under
normal circumstances. When this switch is off (its default setting) the
factory configuration of the EEPROM is protected, so any writes to the
factory area will be ignored. Refer to Figure 2-6 for configuration
settings.
Figure 2-6.
Protect/Change Factory Configuration
Hardware Installation
This section contains general installation instructions for the VXI-MIO
Series modules. Consult your VXIbus mainframe user manual or
technical reference manual for specific instructions and warnings.
1. Plug in your mainframe before installing your VXI module. The
power cord grounds the mainframe and protects it from electrical
damage while you install the module.
Do not
turn on the
mainframe.
Warning:
To protect yourself and your mainframe from electrical hazards,
DO
NOT
turn the mainframe on until you are finished installing your VXI-MIO
Series module.
Load User
Configuration
Load Factory
Configuration
S2 S2
Protect Factory
Configuration
Change Factory
Configuration
S1 S1