Filter
Top Products
3-6 Installation
3.
Route the cable through the "
L"
Shaped Cable Guide, and push the
cable down through the Cable Retention Tabs to hold in place.
4.
Slide the stylus into the Holder on the side of the NCR 5992 unit.
Note: The NCR 5992 host cable should be connected after the
stylus. The host cable is thicker and will keep the stylus cable in
place.
Disconnecting the NCR 5992 Stylus
1.
Place the NCR 5992 in front of you with the bottom of the unit
facing up.
Note: Be careful not to place the unit on a surface where the
graphical display screen can be scratched or damaged.
2.
Gently pull the cable up from the "
L"
Shaped Cable Guide
Retention Tabs.
3.
Press down on the top tab of the NCR 5992 Stylus Connector and
gently pull the connector out of the NCR 5992 Stylus Port.
Connecting the NCR 5992 Host Cable
1.
Place the NCR 5992 in front of you with the bottom of the unit
facing up.
Note: Be careful not to place the unit on a surface where the
graphical display screen can be scratched or damaged.
2.
Hold the NCR 5992 host cable connector behind the cover, with the
flat side of the connector facing up.
3.
Insert the connector into the
NCR 5992 Host Port
.
4.
With your thumb, push the connector into the NCR 5992 port as far
as it will go, locking the cable in the port. All of the
Connector Pins
Metal Shield
should be inside the port when it has been inserted far
enough.
Note: You should be able to pull gently on the cable without
disconnecting it from the NCR 5992.