Filter
Top Products
6-14 Chapter 6: Diagnostics Specification
Note:
For AUX1A port testing, a check reader configured for the 5992
can be used. To test RS485 AUX1A, a check reader configured for an
RS485 IBM 4683 register must be used. To change the communication
parameters, press Cancel to return to the AUX1A screen. The keypad
Yes and No keys are used to scroll through the available options. Refer
to the following Baud Rate, Parity, and Data Bit selections for detailed
information on changing the communication parameters. Once the
parameters have been set, select TEST from the AUX1A screen and
retest.
Press any key on the 5992 keypad (except the Cancel key). That
character is transmitted over the AUX1A port and received and
displayed on the PC. The character will not be displayed on the 5992.
If a key is pressed on the PC keyboard, that character is received on the
5992 and displays on the second line of the unit. If the second line
becomes full, the next key pressed clears the line and displays starting
at the beginning of the line.
Pressing the Cancel key during this test returns the HOST screen.
Pressing Cancel again returns the DIAGNOSTICS HOST RS232 TEST
menu.
Baud Rate Selection
Select
Baud Rate
from the AUX1A screen. The display changes to:
Baud Rate
19200
The default baud rate of “19200” displays. The keypad Yes and No
keys are used to scroll through the available options. The available
baud rate options are:
•
19200
•
9600
•
4800
•
2400
•
1200