Filter
Top Products
Page 5-12 NDA-24230 Issue 2.0
Chapter 5 VisuaLink 128/384 User Guide
The setting screen is displayed. The current setting is displayed.
Note 1:
To select an item use the up and down portion of the
CAMERA
CONTROL
button.
Note 2:
To change a setting use the left and right portion of the
CAMERA
CONTROL
button to toggle through the item.
Note 3:
Appendix A is a table detailing MLP to LSD speed setting relationship.
➂
Press
ENTER
button to define after changing a setting.
➃
Press the
MENU
and
CANCEL
button three (3) times to proceed back to the
video image.
MLP Speed : < 4.0kb/s >
LSD speed : < 1.2kb/s >
Serial port setting
Port 1 : < Camera >
Port 2 : < Console >
User port speed : < 9.6kb/s >
T120 port speed : < 38.4kb/s >
Console speed : < 9.6kb/s >
Console parity : < 8 bit none >
Press ENTER after choosing.
MLP: Multi Layer data sets the speed for NEC far-end control.
Note:
MLP must be active in order to upgrade VL system
on-line.
LSD: Low Speed data sets the speed for far-end camera control.
Serial port setting: Sets the type of control to be activated on the serial port.
User port speed: Sets the data transmission rate for a point-to-point
environment.
T120 port speed: Sets the data transmission rate for a multipoint
environment.
Console speed: Sets the baud speed for a terminal which might be
connected to the VisuaLink serial port.
Console parity: Sets the parity and data length for a terminal which might
be connected to the VisuaLink serial port.
▲