Filter
Top Products
Switching Commands
103
ProSafe M4100 and M7100 Managed Switches
no storm-control unicast level
This command sets the unicast storm recovery threshold to the default value and disables
unicast storm recovery for all interfaces.
Format no storm-control unicast level
Mode
storm-control unicast rate (Global)
Use this command to configure the unicast storm recovery threshold for all interfaces in
packets per second. If the mode is enabled, unicast storm recovery is active, and if the rate of
L2 broadcast traffic ingressing on an interface increases beyond the configured threshold,
the traffic is dropped. Therefore, the rate of unicast traffic is limited to the configured
threshold.
Default
Format storm-control unicast rate <0-14880000>
Mode
no storm-control unicast rate
This command sets the multicast storm recovery threshold to the default value for an
interface and disables multicast storm recovery
.
Format no storm-control unicast rate
Mode
show storm-control
This command displays switch configuration information. If you do not use any of the optional
parameters, this command displays global storm control configuration parameters:
• Broadcast Storm Control Mode may be enabled or disabled. The factory default is
disabled.
• Broadcast Storm Control Level
The broadcast storm control level. The factory default is
5%.
• Multicast Storm Control Mode may be enabled or disabled.
The factory default is
disabled.
• Multicast Storm Control Level
The multicast storm control level. The factory default is
5%.
• Unicast Storm Control Mode may be enabled or disabled.
The factory default is
disabled.
• Unicast Storm Control Level
The unicast storm control level. The factory default is 5%.
Global Config
0
Global Config
Global Config