Filter
Top Products
Quality of Service (QoS) Commands
493
ProSafe M4100 and M7100 Managed Switches
Note: The administrator has to enable tagging on auto-VoIP-enabled ports
to remark the voice data when it is egressed.
Format auto-voip protocol-based {remark <remark-priority> | traffic-class
<tc>}
Mode
• Global Config
• Interface Config
Default
no auto-voip protocol-based {remark | traffic-class}
This command is used to set the traffic-class to the default value.
Format no auto-voip protocol-based {remark <remark- priority> |
traffic-class <tc>}
Mode
• Global Config
• Interface Config
show auto-voip
Use this command to display the auto VoIP settings on the interface or interfaces of the switch.
Format show auto-voip {protocol-based|oui-based} interface {slot/port|all}
Mode
VoIP
Prioritize Type
Class Value
•
If the Prioritization Type is configured as traffic-class, this value is the
queue value.
• If the Prioritization Type is configured as remark, this value is 802.1p
priority used to remark the voice traffic.
Priority
AutoVoIPMode
Example 1: The following shows an example of a CLI display output for the command.
(switch)# show auto-voip protocol-based interface all
VoIP VLAN Id................................... 2
Prioritization Type............................ traffic-class
Class Value.................................... 7
Traffic-class 7
Privileged EXEC
Field Description
The global VoIP VLAN ID.
The type of prioritization used on voice traffic.
The 802.1p priority. This field is valid for OUI auto VoIP.
The Auto VoIP mode on the interface.