Filter
Top Products
Utility Commands
587
ProSafe M4100 and M7100 Managed Switches
no debug igmpsnooping packet
This command disables tracing of IGMP Snooping packets.
Format no debug igmpsnooping packet
Mode
debug igmpsnooping packet transmit
This command enables tracing of IGMP Snooping packets transmitted by the switch.
Snooping should be enabled on the device and the interface in order to monitor packets for a
particular interface.
Default
Format debug igmpsnooping packet transmit
Mode
A sample output of the trace message is shown below.
<15> JAN 01 02:45:06 192.168.17.29-1 IGMPSNOOP[185429992]: igmp_snooping_debug.c(116)
908 % Pkt TX - Intf: 0/20(20), Vlan_Id:1 Src_Mac: 00:03:0e:00:00:00 Dest_Mac:
01:00:5e:00:00:01 Src_IP: 9.1.1.1 Dest_IP: 225.0.0.1 Type: V2_Membership_Report Group:
225.0.0.1
The following parameters are displayed in the trace message:
Format debug igmpsnooping packet
Mode
Privileged EXEC
Privileged EXEC
disabled
Privileged EXEC
Parameter Definition
TX
A packet transmitted by the device.
Intf
The interface that the packet went out on. Format used is slot/port (internal interface
number). Unit is always shown as 1 for interfaces on a non-stacking device.
Src_Mac
Source MAC address of the packet.
Dest_Mac
Destination multicast MAC address of the packet.
Src_IP
The source IP address in the IP header in the packet.
Dest_IP
The destination multicast IP address in the packet.