Filter
Top Products
Utility Commands
515
ProSafe M4100 and M7100 Managed Switches
no boot host retry-count
This command is used to reset the number to the default. The default number is 3.
Format no boot host retry-count
Mode
boot host dhcp
This command is used to enable AutoInstall on the switch for the next reboot cycle. The
command does not change the current behavior of AutroInstall and saves the command to
NVRAM.
Default
Format boot host dhcp
Mode
no boot host dhcp
This command is used to disable AutoInstall on the switch for the next reboot cycle. The
command does not change the current behavior of
AutroInstall and saves the command to
NVRAM
Format no boot host dhcp
Mode
erase startup-config
Use this command to erase the text-based configuration file stored in non-volatile memory. If
the switch boots and no startup-config file is found, the AutoInstall process automatically
begins.
Format erase startup-config
Mode
Dual Image Commands
The software supports a dual image feature that allows the switch to have two software
images in the permanent storage. You can specify which image is the active image to be
loaded in subsequent reboots. This feature allows reduced down-time when you upgrade or
downgrade the software.
Privileged EXEC
Enabled3
Privileged EXEC
Privileged EXEC
Privileged EXEC