NETGEAR M4100-12GF Switch User Manual


 
IPv6 Commands
403
ProSafe M4100 and M7100 Managed Switches
show ipv6 ospf database
This command displays information about the link state database when OSPFv3 is enabled.
If you do not enter any parameters, the command displays the LSA headers for all areas.
Use the optional <areaid> parameter to display database information about a specific area.
Use the other optional parameters to specify the type of link state advertisements to display.
Use external to display the external LSAs. Use inter-area to display the inter-area
LSAs. Use link to display the link LSAs. Use network to display the network LSAs. Use
nssa-external to display NSSA external LSAs. Use prefix to display intra-area Prefix LSAs.
Use router to display router LSAs. Use unknown area, unknown as, or unknown link
to display unknown area, AS, or link-scope LSAs, respectively. Use <lsid> to specify the
link state ID (LSID). Use adv-router to show the LSAs that are restricted by the advertising
router. Use self-originate to display the LSAs in that are self originated. The information
below is only displayed if OSPF is enabled.
Format show ipv6 ospf [<areaid>] database [{external | inter-area {prefix |
router} | link | network | nssa-external | prefix | router | unknown
{area | as | link}}] [<lsid>] [{adv-router [<rtrid>] |
self-originate}]
Modes
• Privileged EXEC
• User EXEC
For each link-type and area, the following information is displayed.
Link Id
Adv Router
Age
Sequence
Checksum
Options
Rtr Opt
Cost
Cost of using this route.
Area ID
The area ID of the area from which this route is learned.
Next Hop
Next hop toward the destination.
Next Hop Intf
The outgoing router interface to use when forwarding traf
fic to the next hop.
Term Definition
A number that uniquely identifies an LSA that a router originates from all other self
originated LSAs of the same LS type.
The Advertising Router. Is a 32 bit dotted decimal number representing the LSDB
interface.
A number representing the age of the link state advertisement in seconds.
A number that represents which LSA is more recent.
The total number LSA checksum.
An integer indicating that the LSA receives special handling during routing calculations.
Router Options are valid for router links only.
Term Definition