NETGEAR M4100-12GF Switch User Manual


 
Routing Commands
291
ProSafe M4100 and M7100 Managed Switches
Number of Active Areas......................... 3 (3 normal, 0 stub, 0 nssa)
ABR Status....................................Disable
ASBR Status...................................Disable
Stub Router...................................FALSE
External LSDB Overflow........................FALSE
External LSA Count............................0
External LSA Checksum.........................0
AS_OPAQUE LSA Count...........................0
AS_OPAQUE LSA Checksum........................0
LSAs Originated...............................0
LSAs Received.................................0
LSA Count.....................................0
Maximum Number of LSAs........................18200
LSA High Water Mark...........................0
Retransmit List Entries........................ 9078
Maximum Number of Retransmit Entries........... 72800
Retransmit Entries High Water Mark............. 72849
show ip ospf abr
This command displays the internal OSPF routing table entries to Area Border Routers
(ABR). This command takes no options.
Format show ip ospf abr
Mode
• Privileged EXEC
• User EXEC
Type
• intra — Intra-area route
• inter — Inter-area route
Router ID
Cost
Area ID
Next Hop
Next Hop Intf
show ip ospf area
This command displays information about the area. The <areaid> identifies the OSPF area
that is being displayed.
Format show ip ospf area <areaid>
Modes
• Privileged EXEC
• User EXEC
Term Definition
The type of the route to the destination. It can be either:
Router ID of the destination.
Cost of using this route.
The area ID of the area from which this route is learned.
Next hop toward the destination.
The outgoing router interface to use when forwarding traffic to the next hop.