Filter
Top Products
Switching Commands
160
ProSafe M4100 and M7100 Managed Switches
than the Snooping Querier’s address, it stops sending periodic queries. If the Snooping
Querier wins the election, then it will continue sending periodic queries.
Default
Format set igmp querier election participate
Mode
no set igmp querier election participate
Use this command to set the Snooping Querier not to participate in querier election but go
into non-querier mode as soon as it discovers the presence of another querier in the same
VLAN.
Format no set igmp querier election participate
Mode
show igmpsnooping querier
Use this command to display IGMP Snooping Querier information. Configured information is
displayed whether or not IGMP Snooping Querier is enabled.
Format show igmpsnooping querier [{detail | vlan <vlanid>}]
Mode
When the optional argument <vlanid> is not used, the command displays the following
information.
Admin Mode
Admin Version
Querier
Address
Query Interval
Querier Timeout
disabled
VLAN Config
VLAN Config
Privileged EXEC
Field Description
Indicates whether or not IGMP Snooping Querier is active on the switch.
The version of IGMP that will be used while sending out the queries.
The IP Address which will be used in the IPv4 header while sending out IGMP queries. It
can be configured using the appropriate command.
The amount of time in seconds that a Snooping Querier waits before sending out the
periodic general query
.
The amount of time to wait in the Non-Querier operational state before moving to a
Querier state.