Filter
Top Products
Routing Commands
257
ProSafe M4100 and M7100 Managed Switches
Advertisement Interval (secs).................. 1
Pre-empt Mode.................................. Enable
Administrative Mode............................ Disable
Accept Mode.................................... Enable
State.......................................... Initialized
Track Interface State DecrementPriority
--------------- ------ ------------------
<0/1> down 10
TrackRoute (pfx/len) StateDecrementPriority
------------------------ ------ ------------------
10.10.10.1/255.255.255.0 down 10
show ip vrrp interface
This command displays information about each virtual router configured on the switch. This
command takes no options. It displays information about each virtual router.
Format show ip vrrp interface brief
Modes
• Privileged EXEC
• User EXEC
Interface
VRID
IP Address
Mode
State
DHCP and BOOTP Relay Commands
This section describes the commands you use to configure BootP/DHCP Relay on the
switch. A DHCP relay agent operates at Layer 3 and forwards DHCP requests and replies
between clients and servers when they are not on the same physical subnet.
bootpdhcprelay cidoptmode
This command enables the circuit ID option mode for BootP/DHCP Relay on the system.
Default
Format bootpdhcprelay cidoptmode
Mode
Term Definition
Valid slot and port number separated by forward slashes.
The router ID of the virtual router.
The virtual router IP address.
Indicates whether the virtual router is enabled or disabled.
The state (Master/backup) of the virtual router.
disabled
Global Config