Filter
Top Products
IPv6 Commands
387
ProSafe M4100 and M7100 Managed Switches
no area nssa translator-stab-intv (OSPFv3)
This command disables the nssa translator’s <stabilityinterval> from the specified
area id.
Format no area <areaid> nssa translator-stab-intv <stabilityinterval>
Mode
area range (OSPFv3)
This command creates a specified area range for a specified NSSA. The <ipaddr> is a valid
IP address. The <subnetmask> is a valid subnet mask. The LSDB type must be specified
by either summarylink or nssaexternallink, and the advertising of the area range can
be allowed or suppressed.
Format area <areaid> range <ipv6-prefix> <prefix-length> {summarylink |
nssaexternallink} [advertise | not-advertise]
Mode
no area range(OSPFv3)
This command deletes a specified area range. The <ipaddr> is a valid IP address.
The
<subnetmask> is a valid subnet mask.
Format no area <areaid> range <ipv6-prefix> <prefix-length>
Mode
area stub (OSPFv3)
This command creates a stub area for the specified area ID. A stub area is characterized by
the fact that AS External LSAs are not propagated into the area. Removing AS External LSAs
and Summary LSAs can significantly reduce the link state database of routers within the stub
area.
Format area <areaid> stub
Mode
no area stub(OSPFv3)
This command deletes a stub area for the specified area ID.
Format no area <areaid> stub
Mode
Router OSPF Config
Router OSPFv3 Config
Router OSPFv3 Config
Router OSPFv3 Config
Router OSPFv3 Config