Filter
Top Products
Quality of Service (QoS) Commands
456
ProSafe M4100 and M7100 Managed Switches
match secondary cos
This command adds to the specified class definition a match condition for the secondary
Class of Service value (the only tag in a single tagged packet or the first or outer 802.1Q tag
of a double VLAN tagged packet). The value might be from 0 to 7.
Default
Format match secondary-cos <0-7>
Mode
match ip6flowlbl
This command adds to the specified class definition a match condition based on the
IP6flowlbl of a packet. The label is the value to match in the Flow Label field of the IPv6
header (range 0-1048575).
Format match ip6flowlbl <label>
Mode
match destination-address mac
This command adds to the specified class definition a match condition based on the
destination MAC address of a packet. The <macaddr> parameter is any layer 2 MAC
address formatted as six, two-digit hexadecimal numbers separated by colons (for example,
00:11:22:dd:ee:ff). The <macmask> parameter is a layer 2 MAC address bit mask, which
need not to be contiguous, and is formatted as six, two-digit hexadecimal numbers separated
by colons (for example, ff:07:23:ff:fe:dc).
Default
Format match destination-address mac <macaddr> <macmask>
Mode
match dstip
This command adds to the specified class definition a match condition based on the
destination IP address of a packet. The <ipaddr> parameter specifies an IP address. The
<ipmask> parameter specifies an IP address bit mask and must consist of a contiguous set
of leading 1 bits.
Default
Format match dstip <ipaddr> <ipmask>
Mode
none
Class-Map Config
Ipv6-Class-Map Configuration mode
none
Class-Map Config
Ipv6-Class-Map Config
none
Class-Map Config