Filter
Top Products
106 Configuring the domain
Because of the amount of traffic generated, Nortel recommends that you
set up syslog on the backend server if possible.
A syslog message generated on a Nortel SNAS device looks like the
following:
Mar 8 14:14:33 192.168.128.24 <ISD-SSL>:
192.168.128.189 TLSv1/SSLv3 DES-CBC3-SHA "GET / HTTP/1.0".
To set up a syslog server to receive UDP syslog messages for all HTTP
requests handled by the portal server, use the following command:
/cfg/domain #/server/adv/traflog
The Traffic Log Settings menu appears.
The Traffic Log Settings menu includes the following options:
/cfg/domain #/server/adv/traflog
followed by:
sysloghost <IPaddr> Specifies the IP address of the syslog server.
udpport <port> Specifies the UDP port number of the syslog
server.
• port is an integer in the range 1–65534 that
indicates the UDP port number. The default is
514.
priority debug|info|
notice
Specifies the priority level of the syslog messages
that are sent. Valid options are:
•
debug—information useful for debugging
purposes only
• info—informational messages
• notice—information about conditions that are
not error conditions but nevertheless warrant
special attention
The default value is info.
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.