Filter
Top Products
64 Managing the network access devices
Figure 2
Adding a switch manually
Deleting a network access devices
To remove a network access devices from the domain configuration, first
disable the switch then delete it. Use the following commands:
/cfg/domain #/switch #/dis
/cfg/domain/switch/delete
The disable and delete commands log out all clients connected
through the switch.
The delete command removes the current switch from the control of the
Nortel SNAS cluster.
Configuring the network access devices
When you first add a network access devices to the Nortel SNAS domain,
the switch is disabled by default. Do not enable the switch until you have
completed configuring it. In particular, do not enable the switch until you
have mapped the VLANs (see “Mapping the VLANs” (page 66)) and
exchanged the necessary SSH keys (see “Managing SSH keys” (page
68)).
If you want to reconfigure the VLAN mappings or delete a VLAN for an
existing network access devices, use the /cfg/domain/switch/dis
command to disable the switch first.
ATTENTION
Remember to enable the network access devices after completing the
configuration in order to activate the network access devices in the Nortel SNAS
network.
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.