Filter
Top Products
20 Introduction
italic text
Variables in command syntax descriptions. Also
indicates new terms and book titles. Where a
variable is two or more words, the words are
connected by an underscore.
Example: If the command syntax is
show at <valid_route>,
valid_route is one variable and you substitute
one value for it.
plain Courier text
Command syntax and system output, for example,
prompts and system messages.
Example: Set Trap Monitor Filters
separator ( > )
Menu paths.
Example: Protocols > IP identifies the IP
command on the Protocols menu.
vertical line ( | ) Options for command keywords and arguments.
Enter only one of the options. Do not type the
vertical line when entering the command.
Example: If the command syntax is
show ip {alerts|routes}, you enter either
show ip alerts or show ip routes, but not
both.
Related information
This section lists information sources that relate to this document.
Publications
Refer to the following publications for information on the Nortel SNAS:
• Nortel Secure Network Access Solution Guide, (NN47230-200)
•
Nortel Secure Network Access Switch 4050 Installation Guide ,
(NN47230-300).
• Nortel Secure Network Access Switch 4050 User Guide for the CLI
(NN47230-100),
• Installing and Using the Security,
• Release Notes for Nortel Ethernet Routing Switch 5500 Series,
Software Release 5.0.1,
• Release Notes for the Ethernet Routing Switch 8300, Software
Release 2.2.8 ,
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.