Filter
Top Products
Configuring the domain 93
Table 5
Configuring the Nortel Health Agent
/cfg/domain #/aaa/nha
followed by:
quick
Launches the Quick Nortel Health Agent
setup wizard, in order to configure default
Nortel Health Agent check settings and the
check result (see “Using the quick Nortel
Health Agent setup wizard in the CLI” (page
96)).
recheck <interval>
Sets the time interval between SRS rule
rechecks made by the Nortel Health Agent
applet on the client machine.
•
interval is an integer that indicates the
time interval in seconds (s), minutes (m),
hours (h), or days (d). The valid range is
60s (1m) to 86400s (1d). The default is
15m (15 minutes).
If a recheck fails, the Nortel SNAS performs
the action specified in the action command
(see "action teardown|restricted" (page 94) ).
heartbeat <interval>
Sets the time interval between checks for
client activity.
•
interval is an integer that indicates the
time interval in seconds (s), minutes (m),
hours (h), or days (d). The valid range is
60s (1m) to 86400s (1d). The default is
1m (1 minute).
hbretrycnt <count>
Specifies the number of times the Nortel
SNAS repeats the check for client activity
when no heartbeat is detected.
• count is an integer in the range 1–65535
that indicates the number of retries. The
default is 3.
If no heartbeat is detected after the specified
number of retries (the inactivity interval),
the Nortel SNAS default behavior is to
terminate the session (see /cfg/domain
#/aaa/nha/status-quo).
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.