Filter
Top Products
Nortel SNAS configuration roadmap 39
4 Configure the network access devices:
a Configure static routes to all the networks behind the core
router.
b Configure the switch management VLAN, if necessary.
c Configure and enable SSH on the switch.
d Configure the Nortel SNAS portal Virtual IP address
(pVIP)/subnet.
e Configure port tagging, if applicable.
For a Layer 2 switch, the uplink ports must be tagged to allow
them to participate in multiple VLANs.
f Create the port-based VLANs.
These VLANs are configured as VoIP, Red, Yellow, and
Green VLANs in step i and step j.
g Configure DHCP relay and IP routing if the switch is used in
Layer 3 mode.
h (Optional) Configure the Red, Yellow, Green, and VoIP filters.
The filters are configured automatically as predefined defaults
when you configure the Red, Yellow, and Green VLANs (step
j). Configure the filters manually only if your particular system
setup requires you to modify the default filters. You can
modify the filters after Nortel SNAS is enabled.
i Configure the VoIP VLANs.
j Configure the Red, Yellow, and Green VLANs, associating
each with the applicable filters.
k Configure the Nortel SNAS ports.
Identify switch ports as either uplink or dynamic. When you
configure the uplink ports, you associate the Nortel SNAS
VLANs with those ports. Clients are connected on the
dynamic ports. You can configure Nortel SNAS ports (both
dynamic and uplink) after Nortel SNAS is enabled globally.
l Enable Nortel SNAS globally.
For more information about configuring an Ethernet Routing
Switch 5510, 5520, or 5530 in a Nortel SNAS network, see
Release Notes for Nortel Ethernet Routing Switch 5500 Series,
Software Release 5.0.1,.
For more information about configuring an Ethernet Routing
Switch 8300 in a Nortel SNAS network, see Release Notes for
the Ethernet Routing Switch 8300, Software Release 2.2.8 ,.
For an example of the commands used to create a Nortel SNAS
configuration, see “Configuration example” (page 385).
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.