Filter
Top Products
52 Initial setup
Alteon iSD NSNAS
Hardware platform: 4050
Software version: x.x
---------------------------------------------------
----
[Setup Menu]
join - Join an existing cluster
new - Initialize host as a new installation
boot - Boot menu
info - Information menu
exit - Exit [global command, always available]
>> Setup#
2 Select the option to join an existing cluster.
>> Setup# join
Setup will guide you through the initial configuration.
3 Specify the management interface port number. This port will be
assigned to Interface 1.
Enter port number for the management interface [1-4]:
<port>
In a one-armed configuration, you are specifying the port you
want to use for all network connectivity, since Interface 1 is used
for both management traffic (Nortel SNAS management and
connections to intranet resources) and client portal traffic (traffic
between the Nortel Health Agent applet on the client and the
portal).
ATTENTION
For consistency, Nortel recommends that you specify the same
port number for the management interface port on all Nortel SNAS
devices in the cluster.
4 Specify the RIP for this device. This IP address will be assigned
to Interface 1.
Enter IP address for this machine (on management
interface): <IPaddr>
The RIP must be unique on the network and must be within the
same subnet as the MIP.
5 Specify the network mask for the RIP on Interface 1.
Enter network mask [255.255.255.0]: <mask>
6 If the core router attaches VLAN tag IDs to incoming packets,
specify the VLAN tag ID used.
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.