Filter
Top Products
Installation and configuration 53
Nortel Integrated Conference Bridge Service Implementation Guide
For the secondary card, configure the following DNs:
• DN pairs (up to nine) – These pairs serve as chairperson and
conferee DNs for single-card conferences (less than 32 ports) on
the secondary card.
Note: If single-number access is being used, DN pairs are not
required. Instead, define the single-number access DN in this
step which callers use to access a simple conference on the
secondary card.
• TUI DN – This is the DN that users dial to set up single-card
conferences on the secondary card. Do not configure this DN, if the
the TUI is not going to be used.
• Transfer DN – This is the DN that transfers dual-card conference
participants from the primary card to the secondary card when the
primary card reaches capacity. The primary card fills up first in a
dual-card conference. Configure this DN for dual-card setup.
• Link DN – This is the DN the creates a speech path between the
primary card and the secondary card for dual-card conferences.
Configure this DN for dual-card setup.
Therefore, for the secondary card, configure up to 22 DNs in LD 23 that
Night Call Forward (NCFW) to the ACD DN of the secondary card.
The main DN must also be configured for the dual-card conference. The
main DN is the DN that conferees dial to enter the dual-card
conference. When the conferees dial the main DN, the main DN
forwards them to the ACD queue of the primary card. When the primary
card becomes full, the transfer DN transfers further conferees to the
secondary card. Use
Table 8 to configure the main DN for dual-card
conferences.
Table 8
LD 23 – Configure the main DN for dual-card conferences
Prompt Response Description
REQ NEW Add new data.
TYPE ACD ACD data block.
CUST xx Customer number.
ACDN xxxx The main DN for dual-card conferences.
MAXP 1 Maximum number of ACD agent positions.