Filter
Top Products
128 Chapter 6 Command line interface
209564-A
Using the test commands
Refer to the Reference for the Passport 8000 Series Command Line Interface
Switching Operations, Release 3.1 and Reference for the Passport 8000 Series
Command Line Interface Routing Operations, Release 3.1 for a complete list of
CLI test commands.
test hardware
Use the test hardware command to run diagnostics on the Passport 8683POS
Module. The command uses the following syntax:
test hardware <ports>
The output from the test hardware command is shown in Figure 52.
Figure 52 test hardware command output
test led
Use the test led command to see if the lights on the port LEDs are functioning
correctly on the Passport 8683POS Module. The command uses the following
syntax:
test led <ports> <tx|rx> <off|yellow|green>
Note: You must specify a slot and port number with the test commands.
Passport-8610:test hardware 10/5
Port: 10/5
IfIndex: 645
Result: success