Filter
Top Products
Chapter 6 Command line interface 93
Using the Passport 8683POS Module
Table 30 config poscard command parameters and variables
Port commands
The port commands allow you to perform general configuration on the Passport
8683POS Module. The syntax for the port config commands is:
• config pos <ports>
• config pos <ports> ip
• config pos <ports> ppp
• config pos <ports> sonet
• config pos <ports> stg
• config pos <ports> info
The port commands, variables and parameters and sub-commands are described
in the following sections.
config pos command
Table 31 describes the parameters and variables for the config pos <ports>
command.
Parameters and variables Description
card-reset Resets the card.
debug <enable | disable> Enables or disables trace messages on the module to
be displayed on the console of the switch.
info Displays the image filename and debug mode for the
module.
pos-console <enable | disable> Prints the trace message POS card. This is a priv
command. When the pos-console is enabled (on the
host), POS prints trace messages on the POS console.
You can also use this command to query information on
the POS card or port. To use this command, you must
be in priv mode. The syntax to enter priv mode is:
config/poscard/<port number>/priv