Filter
Top Products
92 Chapter 6 Command line interface
209564-A
Configuration commands
This section describes the configuration commands available with the Passport
8683POS Module. There are two types of configuration commands:
• Module commands
• Port commands
config poscard commands
The config poscard command allows you to:
• Reset the module
• Enable trace messages
• Display the image filename for the Passport 8683POS Module
The syntax is:
config poscard
<posslot number>
where <posslot number> is the slot number of the module in the Passport 8600
chassis.
Table 30 describes the parameters and variables for the config poscard
command.
Note: If you replace one card with another type of card, Nortel
Networks recommends that you go to the root level of the CLI directory
before you use any CLI commands.