Filter
Top Products
Chapter 6 Command line interface 97
Using the Passport 8683POS Module
Table 34 config pos sonet command parameters and variables
config pos stg command
Use the config pos stg command to configure STG parameters on the
Passport 8683POS Module.
Parameters and variables Description
clock-source <internal | line> Sets the clock source to:
•
<internal>, which means clocking is derived from on-board
clock.
•
<line>, which means clocking is derived from line.
Note that if you have two connected modules, you must set both to
internal or one to line and one to internal; do not set both to line.
framing <sonet | sdh> Sets the framing to:
•
<sonet>, which means the Synchronous Optical Network
format, the standard format used in North America.
•
<sdh>, which means the Synchronous Digital Hierarchy clock
format, the standard format used in Europe.
info Shows the last saved port settings and the next-level CLI commands.
Note that this does not show the current settings, but the last saved
settings.
signal label Operational value of Path Signal Label (C2). The signal label value is
reset when the scramble value is changed.
scramble <enable | disable> Enables or disables scrambling.
section-trace <sectiontrace> Sets the integer that the section trace flag (j0) is set to (1...255).
z0-increment Enables or disables z0 when the framing mode is set to SONET. This
is a priv command - to use this command, you must be in privilege
mode.The syntax to enter priv mode is:
config/pos/<port
number>/sonet priv