Filter
Top Products
96 Chapter 6 Command line interface
209564-A
Table 33 config pos ppp command parameters and variables
config pos sonet command
Use the config pos sonet command to configure SONET parameters on the
Passport 8683POS Module.
Table 34 describes the parameters and variables for the config pos sonet
command.
Parameters and variables Description
bridge-admin-status <open |
close>
Enables or disables the bridge control protocol.
fcs-size<32 | 16> Sets the length of the redundancy check (fcs) to either 32 or 16.
info Shows the last saved port settings and the next-level CLI commands.
Note that this does not show the current settings, but the last saved
settings.
ip-admin-status <open | close> Enables or disables the IP control protocol.
ipx-admin-status <open | close> Enables or disables the IPX control protocol.
ipx-route-protocol <none | rip> Sets the protocol for IPX routing.
lqr-period <interval> Sets the link quality reporting interval. Enter time in ms.
lqr-status <enable | disable> Enables or disables link quality reporting.
lqr-threshold <threshold> Sets the link quality reporting threshold. Enter %.
magic-number <true | false> Sets a random number (“magic number”) used in loopback detection.
True detects loopback; false does not detect loopback.
ppp-stpmode <enable | disable> Encapsulates spanning tree BPDU packets as PPP. When enabled
the BPDUs are encapsulated as in RFC 1638. When disabled, the
BPDUs travel as bridged data (assuming bridge-admin-status is
enabled).
remote-ip<ipaddr> Sets the remote iP address.