9-11
n Assembly of Inverter PCB (Applicable Model : Touch Screen Model)
Inverter Ass’y
Inverter Ass’y
0 4mm
0 0.5mm
A
0 3mm
Connector
PWB
FPC
12
Confirm the direction of the Inverter board when attaching.
30 35mm
Inverter Ass’y
LCD Back Dumper
LCD Ass’y
0 1mm
Inverter Mil Sheet
The gap side is front.
Safety Working
Details of Cable
Avoid running
over this rib.
0 1mm
0 1mm
0 1mm
0 1mm
Attach coming over the end of steel plate by 1 to 2 mm.
Avoid any stress on the Tab part of the
LCD Module because the line comes off.
Wrap of Antenna Cable
Cushion E
Conductive Tape
Wrap over the Antenna Cable
Cushion and the Cable.
6 2mm from the
branch point
Connect
Fix the two Cables.
Insulation Parts
Insulation Parts
Insulation Parts
Insulation Parts
Note for attaching Conductive Tape
Conductive Tape
Tape
Connect the Cable to the
left and right Connectors.
LCD Cable TS
Attach the Inverter Ass’y in the
middle of right and left.
Attach the surplus of the right and left sides on the
Back Dumper as shown below and overlap on the
CCFL Cable. Attach the Pet Sheet over the Core.
LCD Side Cushion E
LCD Side Cushion E
LCD Side Cushion F
Insert it between the ribs.
(Fit to the Cabinet.)
Insert it between the ribs.
(Fit to the Cabinet.)
Insert it between the ribs.
(Fit to the Cabinet.)
Cushion High
Voltage Label
TS PWB
Connect
Attach it to the Connector and FPC.
Avoid getting under the Sheet.
Sield Sheet
Wind round the LCD Cable
a few times and attach it.
Avoid any stress on the Cable
when connecting it.
Hold the Connector part when
connecting/disconnecting.
Sub material: Pet Tape 1
Ensure the edge of the
conductive fabric is not
frayed.
Details of "A"
1 2
mm
Avoid any stress on the Cable when
connecting the CCFL Cable.
Hold the Connector part when
connecting/disconnecting.
Inverter Ass’y