Panasonic CF-19CDBAXVM Laptop User Manual


 
9-9
9.2. Reassembly Instructions
9.2.1. Attention when CF-19 series is repaired
Please execute writing BIOS ID when you exchange the Main Board.
Parts (Sheet and rubber) etc. related various the Conductive Cloth and Heat Spreader cannot be recycled. Use new parts.
9.2.2. Setting up the Inverter Ass'y and LCD UNIT
1. Set the LCD UNIT to the LCD Front Cabinet/TS Panel.
2. Set the TS PCB on the LCD Back Damper, and connect
the 2 Cables to the Connectors (CN900 and CN901).
3. Set the Inverter PCB to the LCD Back Damper, and con-
nect the 2 Cables to the Connectors.
n Assembly of LCD Back Damper (Applicable Model : Touch Screen Model)
Inverter Case
Tape
Inverter PCB
Connector
Connector
LCD Unit
TS PCB
Connector
(CN901)
Connector (CN900)
LCD PWB SPACER ASSY
Asymmetric Shape
A
Remove the Release Paper on
the back side and attach it.
Crosswise: Match to the middle line.
LCD PWB
SPACER ASSY
Insert this between
LCD PCB & LCD Frame.
Match both Holder Sheet and LCD
Back Cushion Side to the right
edge of the Frame. (0 to 0.5 mm)
0 0.5mm
0
0.5mm
0 0.5mm
0 3mm
Detail of "A"
B
C
D
0 1mm
0 0.5mm
0 1mm
1 1.5mm
0 1mm
0 0.5mm
Detail of "D"
Attach to the side surface if the Frame.
(Match to the end of the Frame within
0 to 0.5 mm at the far side.)
0.5mm
0
0.5mm
0.5mm
0.5mm
0.5mm
0.5mm
After setting LCD
Back Damper,
fix them together.
Note: Apply the load to attach. 20 to 30N (2.0 to 3.0 Kgf)
Order of fixing
LCD Side Cushion A
Spacer Sheet
Spacer Sheet
LCD PCB Spacer
Screw the Board and
the Spacer together.
Screw
Detail of "B" Detail of "C"
Screw the Board and
the Spacer together.
LCD Side Cushion C
LCD Side Cushion D
Holder Sheet
LCD Back Cushion Side
LCD Back Damper
Holder Sheet
LCD Back Cushion Side
Lengthwise: Match to the LCD Frame.
Cover the hook of
the Frame. (0 to 0.5 mm)
Cover the hook of
the Frame. (0 to 0.5 mm)
Pass the Cable
under the protrusion.
Pass the Cable
under the protrusion.
Pass the Cable
through the space.
LCD Side Cushion C
Screw
Screw
LCD Side Cushion S
After setting LCD
Back Damper,
fix them together.
Screw
LCD Back Cushion L
LCD Back Cushion S
Match both Holder Sheet and LCD
Back Cushion Side to the right
edge of the Frame. (0 to 0.5 mm)