Filter
Top Products
9-22
9.2.9. Setting the SD PCB, Express Card
and PCMCIA Card
1. Fix the PCMCIA Card using the 4 Screws <N22>
(No1 to No4).
2. Fix the Express Card using the 4 Screws <N22>
(No1 to No4).
3. Fix the SD PCB using the 2 Screws <N5> (No1 to No2).
Note:
Tighten the Screws in the numbered order (No1 to No4).
Tighten the Screws in the numbered order (No1 to No4).
Tighten the Screws in the numbered order (No1 to No2).
Screws <N6>: DRQT26+E4FKL
Screws <N22>: DXQT2+G4FNL
Preparation of PCMCIA Card Connecter
<N22>
<N22>
<N22>
<N22>
<N22>
<N22>
<N22>
<N6>
<N6>
SD PCB
Express Card
PCMCIA Card
No.2
No.1
No.3
<N22>
No.4
No.1
No.2
No.3
No.4
No.1
No.2
1±1
S1
CAUTION
S1:Insulation S2:Bitten S3:Sharp Edge
S4:Part No. Check S5:Other
㪪㪿㪼㪼㫋㫄㪼㫋㪸㫃㩷㫇㪸㫉㫋㩷㫀㫅㫊㫌㫃㪸㫋㫀㫆㫅
(Dotted line)
Reusing the attaching parts is impossible
1.Apply the load when attaching the attaching parts. 20䱊30䰚䯴2䱊3Kgf䯵/cm2
<Notes>
CN Sheet
CN Sheet
CN Sheet
CN Sheet
CN Tape S
CN Tape S
CN Tape L
CN Tape L
CN Tape L
CN Plate
CN Plate
PCMCIA Card
Paste
/CVEJVQVJG
'PFHCEG
The end of metal
fittings is mixed
with a bend.
$QPFGFUWTHCEG
The fact which
doesn't paste out of
metal fittings (tape)
Sheet 0㨪+1
It's stuck on according to the interior angle of the metal fittings.
I bend and stick on together
with a part.
After bend and keep,
released paper is peeled
off and CN sheet
is paste.
After bend and keep,
released paper is peeled
off and CN sheet is paste.
Don't peel off released
paper in an underside.
The surrounding tape
and a seat are stuck on.
Completion
The adhesion which is oil in metal fittings and
ޓthe thing which is sticking in the clean state.
The thing by which a double-stick tape is
ޓsticking in applied pressure 30N/cm2.